In order to keep the integrity of the roof it is recommended to install vmzinc breather membrane on the cold side of the insulation and a vapour control layer adapted to the internal humidity load of the building on the warm side of the insulation.
Cold roof ventilation gap.
No insulation is on top.
The air gap dimensions shown on the drawings are the minimum widths required for clear continuous ventilation air paths at the eaves.
A cold roof is where all of the insulation is placed either between and under or completely under the joists or deck.
The intent of roof venting varies depending on climate but it is the same if you re venting the entire attic or if you re venting only the roof deck.
Ventilation is required for these roofs.
Where this is the case all gaps and holes around service that pass into the cold roof via the ceiling should be sealed to restrict the amount of water vapour that.
Roof voids must be ventilated in order to stop warm air condensing on cold surfaces.
Ventilation at the eaves.
Attic ventilation works on the principle that heated air naturally rises primarily utilizing two types of vents.
Cold deck roof a cold deck roof is where the insulation is placed between the joists rafters or in between the ceiling joists in the case of a pitch roof.
Intake vents located at the lowest part of the roof under the eaves allow cool.
Continuous ventilation openings are made at the top and bottom.
Building regulations state that a ventilation gap of at least 50mm must be in place between the insulation and the underside of the flat roof deck.
Effective attic ventilation systems reduce damaging heat and moisture in your attic promote energy efficiency by helping to reduce the load on your air conditioner in the summer and also reduce the risk of ice dam formation on your roof.
See the benefits of attic ventilation a new roof is more than just shingles.
Condensation encourages rot and mould growth.
You only need ventilation in a cold roof.
Ventilation is not needed in a warm roof.
In this way the roof itself is kept cold.
For both a warm and cold flat roof a vapour control layer must be installed.